News
Design Study --- Waveguide for Purifi 8"
With my recent failure to source a suitable horn and compression driver combo for project No.1736, I decide to go in a different direction. Following on the success of Horn...
Design Study --- Waveguide for Purifi 8"
With my recent failure to source a suitable horn and compression driver combo for project No.1736, I decide to go in a different direction. Following on the success of Horn...
Eighteen Sound - ND1TP 1" compression driver wi...
In this blog post I test the Eighteen Sound ND1TP 1" compression driver with the XT120 Horn. I purchased these drivers new from Eighteen Sound for my own evaluation for use...
Eighteen Sound - ND1TP 1" compression driver wi...
In this blog post I test the Eighteen Sound ND1TP 1" compression driver with the XT120 Horn. I purchased these drivers new from Eighteen Sound for my own evaluation for use...
Peerless OC25SC65-04 with Horn No.1900
In this blog post I test the Peerless OC25SC65-04 with Horn No.1900. The Peerless OC25SC65-04 is relatively affordable listing for only $13.67 USD each at Digikey and $22.49 at Parts...
Peerless OC25SC65-04 with Horn No.1900
In this blog post I test the Peerless OC25SC65-04 with Horn No.1900. The Peerless OC25SC65-04 is relatively affordable listing for only $13.67 USD each at Digikey and $22.49 at Parts...
RCF ND850 2.0 Compression Driver
In this blog post we look at the RCF ND850 2.0 compression driver. This driver features a 3.00" diaphragm and a copper shorting ring for low distortion. The copper shorting...
RCF ND850 2.0 Compression Driver
In this blog post we look at the RCF ND850 2.0 compression driver. This driver features a 3.00" diaphragm and a copper shorting ring for low distortion. The copper shorting...
Celestion Axi2050
In this blog post I test the Celestion Axi2050 compression driver. I test it on my 300Hz Biradial (ES290 No.1670). I began my measuring the impedance sweep which is shown...
Celestion Axi2050
In this blog post I test the Celestion Axi2050 compression driver. I test it on my 300Hz Biradial (ES290 No.1670). I began my measuring the impedance sweep which is shown...
Horn No.1906 on Dayton Audio AMTPRO-4
In this blog post I test Horn No.1906. This is a departure from my usual horn design in that I wanted to see if I could successfully widen the off-axis...
Horn No.1906 on Dayton Audio AMTPRO-4
In this blog post I test Horn No.1906. This is a departure from my usual horn design in that I wanted to see if I could successfully widen the off-axis...